Table 1 below lists wire lengths for one keypad at the end of Note: Install the metal enclosure with the door opening from (toward you) to allow for the wire connections. Make sure the terminal strip is toward the front opening When you slide the board between the grooves of the slots, The PC board to be positioned vertically ( Figure 1 below). There are four slots for board insertions inside the metalĮnclosure, two on the top and two on the bottom. To install the keypad, other peripherals, and sensors, refer to This document to install the system with default settings that Installations should only be done by trained professionals. This is the NX-4V2-Control Panel Installation Instructions. NX-4V2 Control Panel Installation Instructions
0 kommentar(er)
